We’ve covered several portable microscopy setups before, including Foldscope, wooden scope, and our favorite these little UV magnifiers. We like the latter so much because it is capable of both white light, and UV light, and we found we were capable of doing a little bit of fluorescence microscopy on it. That’s where a 2017 […]
Tag: 3D Printing
3D -Fuge: A New Hand Powered Centrifuge
Last year at around this time we covered Paperfuge, a card stock based centrifuge that could spin QBC capillary tubes samples at ~10,000 g. Using the principles laid out with Paperfuge, Gaurav Byagathvalli, Aaron Pomerantz, Soham Sinha, Janet Standeven, and M. Saad Bhamla have come up with 3D-Fuge detailed in a paper on the bioarxiv […]
OMIS: An Open Millifluidic Inquiry System
OMIS is a 3D tool for performing small-scale chemical synthesis and analysis. The system is Arduino-based and consists of an automated syringe pump run by a cheap stepper motor and reaction vessels. The design is meant to allow for fabrication” in one day”, and can pump fluids at rates between 60 and 300 μL/min. The paper, […]
A 3D Printed Platform Jack
Lab Jacks, or Scissor Jacks, are not particularly expensive bits of equipment to begin with. As long as you don’t go through VWR, a good 4×4 inch lab jack will cost you $30, and an 8×8 inch lab jack will cost about twice that. If you want to 3D Print your own lab jack. Thingiverse […]
A Workhorse for 18k: DIY Microscopy with Flexiscope
The Flexiscope is DIY microscope that can be easily converted from upright to inverted configurations in “under 30 minutes”. It’s capable of oblique infrared illumination imaging, multi-channel fluorescent imaging, automated 3D scanning, and even has an electrophysiology configuration. The paper, written by Amy Courtney, Luke Alvey , George Merces, and Mark Pickering which details the […]