GridTape is part of a new system for serial section transmission electron microscopy imaging which excels at high-throughput low-cost nanometer-scale transmission of large volumes. And it’s cheap, for the current price of a comparable multi-beam SEM system, ten grid-tape TEM systems can be built. At first glance the cost sheet looks imposing, but it contains […]
Tag: Articles
DIY Fluorescence Smartphone Microscopy
We’ve covered several portable microscopy setups before, including Foldscope, wooden scope, and our favorite these little UV magnifiers. We like the latter so much because it is capable of both white light, and UV light, and we found we were capable of doing a little bit of fluorescence microscopy on it. That’s where a 2017 […]
OMIS: An Open Millifluidic Inquiry System
OMIS is a 3D tool for performing small-scale chemical synthesis and analysis. The system is Arduino-based and consists of an automated syringe pump run by a cheap stepper motor and reaction vessels. The design is meant to allow for fabrication” in one day”, and can pump fluids at rates between 60 and 300 μL/min. The paper, […]
MesoSPIM: An open-source light-sheet microscope for imaging in cleared tissue
The mesoSPIM (mesoscale selective plane illumination microscopy) project creates open-hardware microscopy platforms for imaging cleared tissue samples. The microscopy setup costs between $170,000 to $240,000 including the optical table and most importantly, the laser itself which will run you between $40,000 to $110,000. This stretches the definition of “On The Cheap”, but the project is […]
A Workhorse for 18k: DIY Microscopy with Flexiscope
The Flexiscope is DIY microscope that can be easily converted from upright to inverted configurations in “under 30 minutes”. It’s capable of oblique infrared illumination imaging, multi-channel fluorescent imaging, automated 3D scanning, and even has an electrophysiology configuration. The paper, written by Amy Courtney, Luke Alvey , George Merces, and Mark Pickering which details the […]